Barnicals
2 Attachment(s)
My boat has been in the slip since March:eek: I didn't have it covered this winter because I knew I was having some things done to it before spring. I added a couple rod holders, had the ECM on the motor replaced and also the O2 sensor.
Around my house, the Maple trees drop those red blossoms that stain the deck. Then the "helicopters" fall by the millions soon after. To avoid this barrage, I put the boat in the slip before these events:D I knew the water was cold and the bottom wouldn't foul during the early weeks. The last several weeks have been a different story. I met Skip to use my sidescan/downscan to locate some anchors, and I knew my returns weren't what I expected. I suspected the transducers were fouled:mad: I pulled the boat this week and sure enough, they were fouled. After I power washed the green "gunk" off, I was afforded a good look at the barnicals:( Some scrapping with a putty knife and screwdriver (in the hard to reach areas) got them looking almost as good as new. I will try to post a before and after photo. Sure wish I had a lift slip like somebody with red curtains:rolleyes: That would be sweet:) 5th (Marty) |
At least your bottom paint still looks good. :)
|
Hey Marty - I was wondering if putting some anti-fouling paint on those transducers (HDS & LSS) would affect their ability to operate correctly. Gotta be a better way.....
Here you go....Check out this thread I found over on THT.... http://www.thehulltruth.com/marine-e...ing-paint.html Don |
Sounds like you need to use your boat more! Barnacles can't hit a moving target :D.
I have been in since early April as well. Since she didn't get over until Oct last year, I didn't bother painting the bottom this spring. :eek: I need to pull and see what I got happening under there one of these days soon. I have put about 150 hours on it so far this season so I am hoping for the best. :rolleyes: As for transducer paints, someone helping me paint the old boat's bottom covered it by mistake with standard West Marine Bottomshield (the cheap stuff) and it seemed to screw up the water temp sensor, unless the bay often heats up to 120*F in the spring??? That was a Garmin 2010C. I usually run them naked and scrape every so often. |
Thanks Don; Ive seen that transducer paint before and never tried it. My old boat (without the swim platform\bracket) was easy to clean while in the water. This one is harder to reach. I will be pulling the boat more often to trailer south (ches beach\point lookout) so it shouldn't be a problem. I just tried to press my luck a little to far this spring:D
5th (Marty) |
Ha Marty,
It is probably not so new anymore, but congratulations on the new boat. The transducer anti foul paints do work pretty well but are not cheap. More trips down south sound like fun. You retired guys get to have all the fun. Maybe you can stay with Don is the rolling Richitt Ritz.:D |
Rich, good to see you back on the board:D Good news/bad neews; one reason I took the job as mate on Patent Pending was to get to know an area of water (south) as well as I know the upper bay. Now that I'm familiar with the area, I want to fish it more often:eek: It's a long ride from Bodkin Creek:mad: so trailering is a better option.
I enjoy the slip. I can take the wife down for dinner and watch the sunset in a little cove. I can run down to the boat and catch spot outside of the creek for livelinning. I can go down and work on some tackle and BS with the other guys at the marina. I just wish the fishing was as good as the midbay. This year, maybe it will be. After all this rain, I expect to see an increase in algae blooms and a loss of oxygen. I hope I'm wrong and the upper bay stays productive. I haven't seen that yellow regulator very often. What's up? 5th (Marty) |
Sometimes when I'm diving - 2-3 boats will come over to get a quick cleaning of the transducer and raw water intakes.
The captains know when the transducer is getting fouled due to needing more gain. When they know I'm in the water - they swing over. Only takes 5 minutes - they notice huge difference right away. If it gets dirty again - just call me. As long as your slip has some type ladder for me to get out - easy job. |
Bought the boat back from Solomons yesterday. She was in the water for 8 weeks.......
The bottom paint definitely need a touch up. I lost about 2000 rpms on the top and some speed. Had a ton of s*** and barnacles on the transducer and trim tab. The lower was barnacled pretty good. Brout her home and scraped her down. The community now smells like a marina. Trash men have a surprise comming:D |
Quote:
|
All times are GMT -5. The time now is 12:02 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Ad Management plugin by RedTyger